St George CC29/E - CONTROL PANEL OPERATION Gas Burner Controls (CG Models)

CONTROL PANEL OPERATION
3. CONTROL PANEL
OPERATION
3.1 Gas Burner Controls (CG Models)
The cooktop burners are ignited
by the in-built electronic ignition controls. The controls must be turned anti-
clockwise to operate and can only be turned clockwise
to the off position. Alternatively the burner may be ignited
manually using matches, cooktop gas lighters
or similar devices, being careful not to risk injury or damage.
To operate the controls ensure
the burners are correctly assembled and positioned over the
gas burner outlets
and the pan supports are correctly positioned
then:-
a) Start
the gas flow by pressing down and turning the control knob corresponding to the burner you
wish to
use. Pressing down on the control knob causes the igniter to spark.
NOTE: For models CG29, CG29 WOK, CG60WOKFFE, CG90WOKFFE
These units are fitted with Flame Failure Safety Devices. These require the controls
to be fully depressed
during ignition
to ensure correct operation. The controls should be held fully down for at least 1 0
seconds
during the ignition and flame
establishment period to ensure the valve remains open after the knob is
released.
b) Once the flame is established the knob need no longer be
pressed and may be turned to your required
setting.
Check for a clear blue flame without excessive yellow tipping.
If burners show any abnormal combustion check
they are correctly
located on the burner base. Sometimes burners may not ignite immediately and may
seem to
"blow" slightly
when they do ignite. This is usually due to air in the gas line, which should clear
itself.
If, after following the instructions, satisfactory performance cannot
be obtained, contact the local gas authority
for advice and assistance.
For minor adjustments see Servicing
and Minor Adjustments.
A 2 yearly
inspection of the appliance by an authorised service agent
will ensure many years of trouble free
service. (Note: This is not provided under warranty).
7