Features UM1956
6/35 UM1956 Rev 4
1 Features
• STM32 microcontrollers in 32-pin packages
• Three LEDs:
– USB communication LED (LD1)
– Power LED (LD2)
– User LED (LD3)
• Reset push-button
• Board expansion connector:
–Arduino
™
Nano
• Flexible board power supply options:
– ST-LINK USB V
BUS
– External source
• On-board ST-LINK/V2-1 debugger/programmer with USB re-enumeration capability:
mass storage, Virtual COM port, debug port
• Support of a wide choice of Integrated Development Environments (IDEs) including
IAR
™
EWARM
(a)
, Keil
®
MDK-ARM
(a)
, GCC-based IDEs (including free SW4STM32
from AC6), Arm
®
Mbed™
(b), (c)
• Arm
®
Mbed Enabled™ (see http://mbed.org)
a. On Windows
®
only.
b. Arm and Mbed are registered trademarks or trademarks of Arm Limited (or its subsidiaries) in the US and or
elsewhere.
c. Refer to the https://www.mbed.com website and to Table 1: Ordering information, to determine which Nucleo
board order codes are supported.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
To Next Page
Loading...
Need help?
General
