ST STM32 NUCLEO-F030R8 User Manual

June 2014 DocID025833 Rev 4 1/55
UM1724
User manual
STM32 Nucleo boards
Introduction
The STM32 Nucleo board (NUCLEO-F030R8, NUCLEO-F072RB, NUCLEO-F103RB,
NUCLEO-F302R8, NUCLEO-F334R8, NUCLEO-F401RE, NUCLEO-F411RE, NUCLEO-
L053R8, NUCLEO-L152RE
) provides an affordable and flexible way for users to try out new
ideas and build prototypes with any STM32 microcontroller lines, choosing from the various
combinations of performance, power consumption and features. The Arduino
™
connectivity support and ST Morpho headers make it easy to expand the functionality of the
Nucleo open development platform with a wide choice of specialized shields. The STM32
Nucleo board does not require any separate probe as it integrates the ST-LINK/V2-1
debugger/programmer. The STM32 Nucleo board comes with the STM32 comprehensive
software HAL library together with various packaged software examples, as well as direct
access to mbed online resources at mbed.org.
Figure 1. STM32 Nucleo board
(1)
1. Picture not contractual.
www.st.com
All manuals and user guides at all-guides.com

ST STM32 NUCLEO-F030R8 Specifications

General

Microcontroller	STM32F030R8
Core	ARM Cortex-M0
Flash Memory	64 KB
SRAM	8 KB
Clock Speed	48 MHz
GPIO Pins	51
Package	LQFP64
On-board Debugger	ST-LINK/V2-1
Operating Voltage	2.0 V to 3.6 V
ADC	12-bit
Communication Interfaces	I2C, SPI, USART
Timers	6 (1x 16-bit advanced, 5x 16-bit general-purpose)

Summary

Introduction

Ordering Information

Conventions

Quick Start

Getting Started

Steps to configure and launch the demo software.

System Requirements

Lists hardware and software requirements for using the board.

Features

Hardware Configuration Variants

Details different oscillator configurations of the target MCU.

Hardware Layout and Configuration

Cutable PCB

Explains the division of the board into ST-LINK and target MCU parts.

Embedded ST-LINK/V2-1

Describes the integrated programming and debugging tool.

Power Supply and Power Selection

Details how to supply power to the Nucleo board from various sources.

LEDs

Explains the function and status indications of the board's LEDs.

Push Buttons

Describes the user and reset push buttons on the board.

OSC Clock

Covers configuration of high-speed and low-speed clock sources.

Solder Bridges

Lists and describes the function of various solder bridges for configuration.

Extension Connectors

Shows signal connections for Arduino and Morpho connectors for specific boards.

Arduino Connectors

Details pin assignments for Arduino Uno R3 compatible connectors.

STMicroelectronics Morpho Connector

Shows pin assignments for the STMicroelectronics Morpho connector.

Mechanical Drawing

Electrical Schematics

References

Revision History