ST STM32 NUCLEO-F030R8 User Manual

Hardware layout and configuration UM1724
10/55 DocID025833 Rev 4
5 Hardware layout and configuration
The STM32 Nucleo board is designed around the STM32 microcontrollers in a 64-pin LQFP
package.
Figure 2 shows the connections between the STM32 and its peripherals (ST-LINK/V2-1,
pushbutton, LED, Arduino connectors and STMicroelectronics Morpho connector).
Figure 3 and Figure 4 show the location of these features on the STM32 Nucleo board.
Figure 2. Hardware block diagram



5(6(7
0LQL
86%
,2
,2 ,2
,2
67/,1.SDUW
(PEHGGHG
67/,1.9
670
0LFURFRQWUROOHU
%
86(5
%
5(6(7
/('
/'
0&8SDUW
6:'
0RUSKRH[WHQVLRQKHDGHU
$UGXLQRFRQQHFWRU
$UGXLQRFRQQHFWRU
0RUSKRH[WHQVLRQKHDGHU
069
All manuals and user guides at all-guides.com

ST STM32 NUCLEO-F030R8 Specifications

General

Microcontroller	STM32F030R8
Core	ARM Cortex-M0
Flash Memory	64 KB
SRAM	8 KB
Clock Speed	48 MHz
GPIO Pins	51
Package	LQFP64
On-board Debugger	ST-LINK/V2-1
Operating Voltage	2.0 V to 3.6 V
ADC	12-bit
Communication Interfaces	I2C, SPI, USART
Timers	6 (1x 16-bit advanced, 5x 16-bit general-purpose)