ST STM32 NUCLEO-F030R8 - References; Revision History

To Next Page

To Previous Page

References UM1724

54/55 DocID025833 Rev 4

8 References

9 Revision history

1. UM1075 - ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32, User

manual

Table 23. Document revision history

Date Revision Changes

10-Feb-2014 1 Initial release.

13-Feb-2014 2 Updated Figure 1, Chapter 4 and Table 9.

11-Apr-2014 3

Extended the applicability to NUCLEO-F302R8.

Updated Table 1: Ordering information, Section 5.11:

Arduino connectors and Section 5.12:

STMicroelectronics Morpho connector.

Updated Figure 1

10-June-2014 4

Updated the board figure: Figure 1.

Updated HSE and LSE configuration description:

Section 5.7.1, Section 4 and Section 5.7.2. Extended

the applicability to NUCLEO-F334R8, NUCLEO-

F411RE and NUCLEO-L053R8.

All manuals and user guides at all-guides.com

Main Page

Figure 1. STM32 Nucleo Board (1)1
Table of Contents2
Ordering Information6
Table 1. Ordering Information6
Conventions7
Table 2. ON/OFF Conventions7
Quick Start8
Getting Started8
System Requirements8
Features9
Hardware Configuration Variants9
Hardware Layout and Configuration10
Figure 2. Hardware Block Diagram10
Figure 3. Top Layout11
Cutable PCB12
Figure 4. Bottom Layout12
Embedded ST-LINK/V2-113
Table 3. Jumper States13
Figure 5. Typical Configuration13
Drivers14
ST-LINK/V2-1 Firmware Upgrade14
Using the ST-LINK/V2-1 to Program/Debug the STM32 on Board14
Figure 6. Updating the List of Drivers in Device Manager14
Using ST-LINK/V2-1 to Program/Debug an External STM32 Application15
Table 4. Debug Connector CN4 (SWD)15
Figure 7. Connecting the STM32 Nucleo Board to Program the On-Board STM3215
Power Supply and Power Selection16
Power Supply Input from the USB Connector16
Figure 8. Using ST-LINK/V2-1 to Program the STM32 on an External Application16
External Power Supply Inputs: VIN and EV517
Table 5. JP1 Configuration Table17
Table 6. External Power Sources18
Table 7. Power-Related Jumper18
External Power Supply Input: + 3V320
External Power Supply Output20
Leds20
Table 8. +3.3V Eternal Power Source20
Push Buttons21
Jp6 (IDD)21
OSC Clock22
OSC Clock Supply22
OSC 32 Khz Clock Supply23
USART Communication23
Solder Bridges25
Table 9. Solder Bridges25
Extension Connectors27
Figure 9. NUCLEO-F030R827
Figure 10. NUCLEO-F072RB27
Figure 11. NUCLEO-F103RB28
Figure 12. NUCLEO-F302R828
Figure 13. NUCLEO-F334R829
Figure 14. NUCLEO-F401RE29
Figure 15. NUCLEO-F411RE30
Figure 16. NUCLEO-L053R830
Figure 17. NUCLEO-L152RE31
Arduino Connectors32
Table 10. Arduino Connectors on NUCLEO-F030R8, NUCLEO-F072RB32
Table 11. Arduino Connectors on NUCLEO-F103RB34
Table 12. Arduino Connectors on NUCLEO-F302R836
Table 13. Arduino Connectors on NUCLEO-F334R837
Table 14. Arduino Connectors on NUCLEO-F401RE, NUCLEO-F411RE39
Table 15. Arduino Connectors on NUCLEO-L053R840
Table 16. Arduino Connectors on NUCLEO-L152RE41
Stmicroelectronics Morpho Connector43
Table 17. Stmicroelectronics Morpho Connector on NUCLEO-F030R843
Table 18. Stmicroelectronics Morpho Connector on NUCLEO-F072RB44
Nucleo-F334R844
Table 19. Stmicroelectronics Morpho Connector on NUCLEO-F103RB45
Table 20. Stmicroelectronics Morpho Connector on NUCLEO-F302R846
Table 21. Stmicroelectronics Morpho Connector on NUCLEO-F401RE46
Nucleo-F411Re46
Table 22. Stmicroelectronics Morpho Connector on NUCLEO-L152RE48
Nucleo-L053R848
Mechanical Drawing49
Figure 18. STM32 Nucleo Board Mechanical Drawing49
Electrical Schematics50
Figure 19. Schematic (1/4)50
Figure 20. Schematic (2/4)51
Figure 21. Schematic (3/4)52
Figure 22. Schematic (4/4)53
References54
Revision History54
Table 23. Document Revision History54

ST STM32 NUCLEO-F030R8 - References; Revision History

Table of Contents

Related product manuals