ST STM32G0 User Manual

Contents
1 Features...........................................................................2
2 Ordering information ..............................................................3
2.1 Product marking ...............................................................3
2.2 Products and codification ........................................................3
3 Development environment .........................................................4
3.1 System requirements ...........................................................4
3.2 Development toolchains .........................................................4
3.3 Demonstration software .........................................................4
4 Conventions.......................................................................5
5 Quick start ........................................................................6
5.1 Getting started .................................................................6
6 Hardware layout and configuration.................................................7
6.1 PCB layout ....................................................................7
6.2 Mechanical drawing ............................................................9
6.3 Embedded ST-LINK/V2-1.......................................................10
6.3.1 Drivers ...............................................................11
6.3.2 ST-LINK/V2-1 firmware upgrade ............................................11
6.4 Power supply .................................................................11
6.4.1 Power supply input from the USB connector ...................................11
6.4.2 External power supply inputs ..............................................12
6.4.3 External power supply output ..............................................13
6.5 Board functions ...............................................................13
6.5.1 LEDs .................................................................13
6.5.2 Push-button ...........................................................13
6.5.3 Current consumption measurement (IDD).....................................13
6.5.4 Virtual COM port (VCP): USART............................................14
6.6 Solder bridges ................................................................14
7 Board connectors ................................................................16
7.1 Arduino
™
Nano V3 connectors CN3 and CN4......................................16
UM2591
Contents
UM2591 - Rev 1
page 22/26

ST STM32G0 Specifications

General

Series	STM32G0
Core	ARM Cortex-M0+
Operating Frequency	Up to 64 MHz
ADC Resolution	12-bit
Operating Voltage	1.7 V to 3.6 V
Communication Interfaces	USART, SPI, I2C, USB, CAN
Operating Temperature	-40°C to 85°C
Package Options	LQFP, UFQFPN, TSSOP

Summary

Introduction

Ordering Information

Product Marking

Details on product marking for identification and traceability.

Products and Codification

Explanation of product codification and available variants.

Development Environment

System Requirements

Specifies the necessary system requirements for development.

Development Toolchains

Lists supported development toolchains and IDEs for the board.

Demonstration Software

Information about preloaded demonstration software and its source.

Quick Start

Getting Started

Provides initial steps and guidance for starting with the Nucleo-32 board.

Hardware Layout and Configuration

PCB Layout

Details the physical layout of components on the PCB, including top and bottom views.

Mechanical Drawing

Shows the mechanical dimensions and drawings of the board.

Embedded ST-LINK/V2-1

Information about the integrated ST-LINK/V2-1 debugger and firmware upgrade.

Power Supply

Details board power supply options via USB and external sources, with configuration details.

Board Functions

Describes board functions including LEDs, push-button, current measurement, and VCP.

Solder Bridges

Explains the configuration and function of various solder bridges on the board.

Board Connectors

Arduino™ Nano V3 Connectors CN3 and CN4

Details the Arduino Nano V3 compatible connectors and their pinout.

Federal Communications Commission (FCC) and Industry Canada (IC) Compliance Statements

FCC Compliance Statement

FCC compliance information, including Part 15 rules and user modifications.

IC Compliance Statement

Industry Canada (IC) compliance statement and identification.

CE Conformity

Warning

Warning regarding CE conformity for Class A product and potential radio interference.

Revision History