Stabila LD 520 User Manual

Instructions on inserting batteries, recommending high-quality ones and advising on replacement.

Step-by-step guide on how to turn the device ON and OFF, including automatic switch-off.

Describes how to perform continuous measurement to find minimum and maximum values.

Instructions on adding or subtracting consecutive measurements to calculate areas or volumes.

Step-by-step guide to calibrate the tilt sensor for accurate angle measurements.

Basic operation for measuring a single distance, including target surface considerations.

Step-by-step guide to measure areas by taking two distance measurements.

Instructions on calculating volume by taking three distance measurements.

Guide to measure triangular areas using three distance measurements.

How to measure height differences to a reference point and terrain profiles.

Measuring indirect distances, lengths, slopes, and heights of sloped objects.

Method for determining heights of buildings/trees without reflective points using inclination.

How to measure trapezium areas using multiple distance and angle measurements.

Function to mark defined lengths or points by entering distances and moving along a line.

Using the 2-point Pythagoras function for indirect horizontal measurements.

Using the 3-point Pythagoras function for indirect measurements, often horizontal.

General safety advice for responsible use and adherence to instructions.

Warnings about erroneous measurements due to defects or misuse, and caution against self-repair.