Stabila LD 520 - Calibration of tilt sensor (Tilt Calibration)

LD 520
10
ENSettings
Calibration of tilt sensor (Tilt Calibration)
1
2
3
Place device on absolutely flat surface.
180°
4
180°
5
Turn the device horizontally by 180°
and place it again on absolutely flat
surface.
6
7
Place device on absolutely flat surface.
180°
8
180°
9
Turn the device horizontally by 180°
and place it again on absolutely flat
surface.
10
i
After 2 sec
the device
goes back to
the basic
mode.