Stack-On PC-1702-RFID - SYSTEM SETTINGS AND RESET; Toggling Keypad Sound and Clearing Codes

TURNING THE KEYPAD SOUND
OFF/ON
Your case comes with the "Beep" sound
turned on. You can turn off the "Beep" sound
of the keypad by pressing RFID buon
and holding for 3 seconds unl the panel
flashes green then purple.
To turn the "Beep" sound on, press the RFID
buon and hold for 3 seconds unl the
panel flashes green then purple.
CLEARING ALL CODES
Clearing the codes will erase the signature of the
programmed RFID devices and the programmed
electronic combinaon.
Locate the reset buon on the inside of the case
and press and hold unl the green light flashes and
beeps 10 mes (if the sound is turned on).
NOTE: Failure to follow instrucons
will not erase the codes.
All recorded devices and combinaon will be
erased. You will need to reprogram all devices and
the combinaon described in the Programming
Secons of this instrucon sheet.
STACK-ON ® PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
IMPORTANT
Keep keys, RFID devices and your combinaon
number is a secure place, away for children.
Keep this record of your serial number and
combinaon in a secure place separate from your
case. To order a replacement RFID device, or key
set, follow the instrucons on the aached form.
NOTE: This unit is not an approved California
Department of Jusce firearm safety device.
40720-1702
6
16