Stack-On PDS-1500-B - Locking the Safe; Clearing the Memory; Battery Replacement

40634-1510
3
12
CLEARING THE MEMORY
To clear the memory of all recorded ngerprints,
locate the reset buon on the inside of the door
and press this buon for about 5 seconds until
the green light ashes 10 times with 10 beeps(if
the sound is turned on). All recorded scans will
be erased.
To lock the safe, close the door and turn the knob to
the le to the 12:00 position.
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds aer the ngerprint
is entered, wait a minimum of 6 seconds from the
time you have successfully scanned your nger to
lock the safe. Also, when locking the safe, always
make sure the knob is turned completely to the
le to the 12:00 position. If the knob is not
turned to the 12:00 position during the locking
process, the locking mechanism will not lock.
NOTE: Do not mix old and new baeries. Do
not mix alkaline, standard or rechargeable
baeries.
is safe uses 4 - AA baeries. Under normal use,
baeries will last about 1 year.
NOTE: If the baeries are low, the yellow light
will ash when you press the scanner.
To replace the baeries, open the baery
compartment on the back of the door by pushing
the tab in the direction of the arrow and install all
new baeries.
BATTERY REPLACEMENT
NOTE: For security you must record a
ngerprint. Failure to do so will compromise
the safety and security of the safe.