Stack-On PDS-1500-B - Selecting a Location; Maintenance

40634-1510
4
12
MAINTENANCE
IMPORTANT
Keep keys in a secure place, away from children. Keep this
record of your serial number in a secure place separate from
your safe. To order a replacement key set, follow the
instructions on the aached form.
STACK-ON PRODUCTS COMPANY
P.O. BOX 489
WAUCONDA, IL 60084
SECURING THE SAFE
Select an appropriate sized drawer for your safe. Place
the safe in the drawer and try opening and closing the
safe and drawer. Do not aempt to close the drawer
with the safe open.
Place the safe in the desired drawer and mark the
mounting holes with a pencil. Remove the safe
and drill the pilot holes for the screws. Replace
the safe in the drawer and insert the screws
through the mounting holes and drawer boom.
Secure the bolt by tightening the Nylock nut on
the screws. (Figure 1)
Figure 1
SELECTING A LOCATION
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
TURNING THE SOUND OFF/ON
To turn the sound o, press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear a two beeps and
the green light ashes twice.
Your safe comes with the beep sound turned on.
is safe must be mounted into a drawer. For
optimal safety and security, the safe should be
installed in an isolated, dry and secure area.
NOTE: is safe must be mounted into a drawer.
Failure to do so will compromise the safety and
security of the safe.
If the door of the safe starts to rub on the door
frame, open the door per the instructions above.
By the door hinges you will nd a threaded stem.
Use an Allen Wrench to tighten the threaded stem.
is will realign the door.
Tools Required:
Phillips screwdriver
5mm Allen wrench
e biometric scanner may be cleaned with
household glass cleaner and a coon cloth.