Remove the shelf for beer access to the baery compartment. Push the baery
cover locking tab with a screwdriver to release the cover. Install the (4) AA
alkaline baeries as shown. Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
NOTE: If the baeries are low the red indicator will stay on aer scanning.
Replace with 4 new AA alkaline baeries as shown.
NOTE: Do not mix old and new baeries. Do not mix alkaline, standard or
rechargeable baeries.
1. Key lock
2. START button
3. Fingerprint scanner
4. Red indicator light
5. Green indicator light
6. Reset button (inside safe)
7. Battery Compartment (inside safe)
40260-1202
12
1
Record the serial number from the tag on the door front.
Tools required: Flat head screwdriver, 10mm wrench, drill, 3/8”
(9.5mm) drill bit.
Keep keys in a secure place away from children.
DO NOT store keys or this form in the safe.
When you rst install the baeries, you can open the safe by pressing the
START buon (2). For security you must record your ngerprint aer you
install the baeries so the safe will read only the recorded ngerprints.
Instructions
CONTROL FEATURES
When you rst receive your safe you will need to open the door with the key
in order to install the baeries. Baeries are included and are located
inside the safe.
GETTING STARTED
INSTALLING THE BATTERIES
To open the safe, insert key into lock and turn clockwise until the door
automatically opens. NOTE: You must turn the key back to the locked
position before you are able to close and lock the door.
Serial #:
NOTE: is key has also been provided if the baeries run low. If you
lose your key, you may purchase a replacement key by referencing the
serial number located on the front of the door. See section regarding
replacement keys for further information.
To Next Page
Need help?
General
