Stahl-electronics BS Series - 10 Output Connector Pinout (Subd)

BS and BSA Bias Supply Series and User Manual, Rev 2.60
www.stahl-electronics.com phone: +49 6242-504882, fax: +49 6242 504884
24
Fig. 9.7: The typical short term stability of an output channel at 0V is shown here (BS series). Measurement
device was a Fluke 8846A multimeter, 0.5sec. averaging per data point. One measurement point was taken every
second.
Fig. 9.7: The typical short term stability of a 100mV device, at 100mV is shown here (BS series). Measurement
device was a Keithley DMM7510 multimeter, 1sec. averaging per data point.
10. Output Connector Pinout (SubD)
(available as special ordering option)
25pole SubD-Pinout, female