5/16 Rev. B 57-02497 5
B-SERIES CONDENSING UNIT FEATURES
STANDARD COMPONENTS
The B-Series units offer the most complete set of standard features (pre-wired and mounted except as noted)*
These include:
● Liquid line and suction line vibration absorbers (eliminators) for semi-hermetic units only.
● Adjustable dual pressure control
● Head pressure control (flooding valve)
● Corrosion-resistant hinged weather hood with lockable snap-down hood latch for easy installation and
service access
● Suction line filter
● Heavy-duty 12 gauge galvanized steel legs
● Pre-wired electrical control panel with timer and circuit breaker or fuse block
● Crankcase heater
● Liquid line filter/drier
● Sight glass
● Liquid and suction line kit with service valve
● Liquid line solenoid valve (shipped loose)
● Timer
● Generously-sized condenser (for 105° to 110° ambient)
● Large liquid receiver (good for maximum 250 ft. line run)
● Defrost heater contactor when required
● Compressor contactor used in 1
1
/2 HP units and up
● PSC fan motors
● One year limited compressor warranty
*Components may vary depending on horsepower and application. Consult our factory for verification of
standard and optional components.
OPTIONALLY AVAILABLE
● Water-cooled units
● Special voltages
● Oil separator
● Condensing units above 40 H.P.
● Insulated and heated receiver (thermostatically controlled)
● Suction accumulator (shipped loose)
● Coated condenser coils
● Phase loss/low voltage monitor
● Factory pre-assembled evaporator coil (includes factory pre-mounting of thermostatic air control and
expansion valve)
● Pre-mounted solenoid at evaporator
● Extended four years limited compressor warranty
● Master Controller electronic control system
● Reverse cycle defrost
To Next Page
Loading...