Stanley ProSert XTN20 User Manual

This instruction manual must be read by any person installing or operating this tool with particular
attention to the following safety rules.
Always wear impact-resistance eye protection during operation of the tool. The grade of protection
required should be assessed for each use.
Use hearing protection in accordance with employe's instructions and as required by occupational
helth and safety regulations.
Use of the tool can explose the operator's hands to hazards, including crushing, impacts, cuts and
abrasions and heat. Wear suitable gloves to protect hands.
1. Safety Denitions
The denitions below describe the level of severity for each signal word. Please read the manual and pay
attention to these symbols.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious
injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death
or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate
injury.
CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not
avoided, may result in property damage.
Improper operation or maintenance of this product could result in serious injury and property damage.
Read and understand all warnings and operating instructions before using this equipment. When using
power tools, basic safety precautions must always be followed to reduce the risk of personal injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
1.1 General Safety Rules
• For multiple hazards, read and understand the safety instructions before installing, operating, repairing,
maintaining, changing accessories on, or working near the tool. Failure to do so can result in serious
bodily injury.
• Only qualied and trained operators must install, adjust or use the tool.
• DO NOT use outside the design intent of Placing STANLEY Engineered Fastening Rivet Nuts.
• Use only parts, fasteners, and accessories recommended by the manufacturer.
• DO NOT modify the tool. Modications can reduce the eectiveness of safety measures and increase the
risks to the operator. Any modication to the tool undertaken by the customer will be the customer’s
entire responsibility and void any applicable warranties.
• Do not discard the safety instructions; give them to the operator.
• Do not use the tool if it has been damaged.
• Prior to use, check for misalignment or binding of moving parts, breakage of parts, and any other
condition that aects the tool’s operation. If damaged, have the tool serviced before using. Remove any
adjusting key or wrench before use.
• Tools shall be inspected periodically to verify that the ratings and markings required by this part of
ISO 11148 are legibly marked on the tool. The employer/user shall contact the manufacturer to obtain
replacement marking labels when necessary.
• The tool must be maintained in a safe working condition at all times and examined at regular intervals
for damage and function by trained personnel. Any dismantling procedure will be undertaken only by
trained personnel. Do not dismantle this tool without prior reference to the maintenance instructions.
6
ENGLISH

Stanley ProSert XTN20 Specifications

General

Brand	Stanley
Model	ProSert XTN20
Category	Power Tool
Language	English