No detergent sucked in
Adjustable nozzle on high pressure setting
set nozzle (6) on “ ” setting (Fig.C)
Detergent too dense Dilute with water
High pressure hose extension being used Fit original hose
Deposits or restriction in detergent circuit
Flush with clean water and eliminate any
restrictions. If the problem persists, contact an
Authorized service Centre
Water escapes from thermo- stat valve
Water temperature inside pump head has ex-
ceeded max. rated value stated on nameplate
With appliance in operation, do not stop the water
jet for more than 5 minutes at a time
* If the motor starts and does not restart during operation, wait 2-3 minutes before repeating the start-up procedure (overload cutout has
been tripped).
If the problem recurs more than once, contact your nearest Authorized Service Centre.
ENGLISH
13
To Next Page
Loading...
