– 9 –
3-2. Connecting to a Peripheral Unit
You can connect a peripheral unit to the printer using a modular plug. The following de-
scribes how to install the ferrite core and make the actual connection. See “Modular plug” on
page 30 PoweredUSB for details about the type of modular plug that is required. Note that
this printer does not come with a modular plug or wire, so it is up to you to obtain one that
suits your needs.
CAUTION
Make sure that the printer is turned off and unplugged from the AC outlet and that the compu-
ter is turned off before making connections.
(1) Connect the peripheral drive cable to the connector on the rear panel of the printer.
CAUTION
Do not connect a telephone line into the peripheral drive connector. Failure to observe this
may result in damage to the printer.
Also, for safety purposes, do not connect wiring to the external drive connector if there is a
chance it may carry peripheral voltage.
[U Model]
[PU Model]
To Next Page
Loading...
