– 11 –
3-5. Connecting the Power Cord
Note: Before connecting/disconnecting the power cord, make sure that power to the
printer and all the devices connected to the printer is turned o. Also make sure the
power cable plug is disconnected from the AC outlet.
(1) Check the label on the back or bottom of the printer to make sure its voltage matches that
of the AC outlet. Also make sure the plug on the power cord matches the AC outlet.
(2) If the power cord is not attached to the printer, plug the appropriate end into the AC inlet
on the back of the printer.
(3) Plug the power cord into a properly grounded AC outlet.
CAUTION
If the voltage shown on the label on the bottom of your printer does not match
the voltage for your area, contact your dealer immediately.
To Next Page
Loading...
