– 32 –
(*2)
Sets the timeout time when getting the address from a DHCP server. e factory default
setting (when set to ON) is 20 seconds.
When set to on, there is no timeout.
If this product is connected directly to an intelligent switch or intelligent hub, the physi-
cal link may take some time to become established. As a result, a timeout will occur while
waiting to get the DHCP address, and it will fail to get the IP address. In such cases, set
DIPSW1-3 = OFF to have no IP address acquisition timeout.
Note: is feature is supported from rmware version 3.0.
For the printer's rmware, contact your dealer.
To Next Page
Loading...
