– 3 –
PARTS REPLACEMENT
1. Rear Cover Unit
(1) Turn off the power switch 1, disconnect the power
cord from the wall outlet.
(2) Push the cover open lever 2 and open rear cover
unit 3.
(3) Allowing about 5mm of uniform slackening at points
A (left/right) of the rear cover unit 3, along the
arrow direction, remove it from case unit.
(4) Remove front cover 4.
2. Case Unit
(1) Turn off the power switch, disconnect the power
cord from the wall outlet.
(2) Remove the rear cover unit according to the
procedure described in item 1.
(3) Remove
• Four screws 1
• Case unit 2
3
2
A
A
4
1
1
1
1
2
1
To Next Page
Loading...
