– 17 –
ENGLISH
Note: When using a paper roll with an
57.5 mm width, install the optional
paper roll holder in the groove in the
printer.
Then, change the setting for memory
switch 4 to change the print width from
72 mm to 50.8 mm.
For instructions on setting the memory
switch, please refer to the separate Pro-
grammer’s Manual.
If a paper roll with a 57.5 mm width
has been used, a paper roll with a
79.5 mm width cannot be used.
(Changing from the smaller roll to a
larger roll will cause part of the print
head to rub against the platen and
deteriorate.)
Paper roll holder
3) Push down both sides of the printer
cover to close.
Note: Make sure that the printer cover
is securely closed.
4) Tear Bar Model:
Tear off the paper as shown.
Auto Cutter Model:
If the printer cover is closed after
turning on the power, the cutter op-
erates automatically and the front
end of the paper is cut.
Tear Bar Model
To Next Page
Loading...
