Star Micronics TSP650II SERIES - Changing the Paper Width

-
11
-
Paper roll guide
A
3-6-2. Changing the Paper Width
When using 57.5 mm width paper rolls, attach the supplied paper roll guide to the printer. When you change the eective
print width (paper roll width), change the printer utility’s memory switch setting.
For details, see the printer utility help.
(1) Insert the paper roll guide rmly into the slot in the printer labeled "r58" as shown in the gure below.
(2) Secure the paper roll guide in place by pushing the section marked as “A” in the gure.
Note1 : Do not insert the paper roll guide into the slot labeled "r 65".
It may cause problems.
2: Do not change the paper width while the printer is in use.
e amount of wear on the thermal head, rubber roller, and cutter varies depending on the paper width.
is varying amount of wear may cause problems in printing and cutting.