Replacement
1. Replacing the interface board
1 Make sure that the power cord is unplugged.
2 Remove the 2 screws.
3 Remove the interface board unit in the direction of the arrow.
4 Slide the new interface board into the printer until it is firmly seated.
Note1) Insert the interface board so that it connects with the connector.
2) Make sure that the plastic sheet is inserted into the printer.
5 Secure the interface board using the two screws.
6 Once the interface board has been connected, perform a self-print test. Also, make sure that the printer recognizes
the interface board.
When recognized: Prints “Interface: Wireless NIC”. If not, contact your dealer.
Caution: Do not replace the CompactFlash card.
2. Dip Switch Setting
Change DIP Switch 2 to ON to initialize the setting information when the power is turned on.
DIP Switches 1 to 2 are all OFF at the factory.
3. LED Display
Green : Lights when packets are received.
4. Installing the Ferrite Core (EU only)
Note that the peripheral drive cable is not provided. Please use a cable that meets specifications, see the separate
user’s manual. Affix the ferrite core onto the peripheral drive cable to prevent radio interference as shown in the
illustration below.
1 Affix the ferrite core onto the peripheral drive cable as shown in the illustration below.
LED
Screws
DIP switch
ConpactFlash
card
Plastic sheet
DipSwitch ON OFF
1 Fixed at OFF
2 Initialize of settin
g
information
Ferrite core
(EU only)
Ethernet cable
EU only
To Next Page
Loading...
