Star Micronics TSP743II Series - 3-7-5. Resetting Bluetooth Settings

3-7-5. Resetting Bluetooth Settings
e following procedure explains how to initialize settings that you have changed such as the PIN code, device name,
and so on.
(1) While inserting a thin object such as the tip of a pen and holding down the RST button on the rear of the printer,
turn on the printer's power switch. e POWER LED (green) and the ERROR LED (red) on the front of the printer
start ashing.
(2) Hold down the RST button for 4 seconds or more (note 1), and then release it.
(3) Aer you release the RST button, if the LED stops ashing and the POWER LED remains lit green within 12 seconds,
initialization is complete. If the LED continues to ash for longer than 12 seconds aer releasing the RST button, this
indicates that initialization was not successful. Turn o the printer's power and then try again from step 1.
(4) Turn o the printer's power switch and delete the pairing setup with the higher ranked device.
Note 1: In step 2, if you do not hold down the RST button for long enough, initialization will not complete correctly.
For F/W Ver2.0, Ver3.0a, and Ver3.0b interfaces
In step 2, you need to hold down the RST button for 8 seconds or more.
Also, aer nishing steps 1 to 3, to check that initialization was completed correctly, perform self-printing.
If the second sheet (*** Bluetooth Information ***) is not printed, initialization has not been completed cor-
rectly. If this happens, turn o the printer's power, and then try again from step 1.
(You can check the rmware version from the self-printing results. See page 14 for the self-printing procedure.)
2: Do not turn o the printer during initialization; otherwise initialization will not complete correctly.
3: If initialization is not completed correctly, turn o the printer's power and then try again from step 1.
-
21
-
PAIR
RST
PAIR
RST
Hold down for 4 seconds or more
RST button