Star SM-S220I SERIES - Page 24

- 17 -
Printer Status Action
LED
LCD Buzzer
POWER
(Green)
ERROR
(Red)
Printer Initialization(Power On) Flickering Flickering
Display :
[ Bluetooth Mode ]
Back Light : Flickering during initialization
Beep 3
On-Line
COM1
Cable not
Stand-by
ON OFF
Display : [ Bluetooth Mode ]
Bluetoothconnected/disconnected
Back Light : 1 sec ickering and OFF
Nothing
Cable Connected
Display : [ Cable Detect ]
g
[ UART Mode ]
Back Light : 1 sec ickering and OFF
Beep 2
COM1
Cable
Connected
Stand-by
Display : [ UART Mode ]
Back Light : 1 sec ickering and OFF
Nothing
Taking O Cable
Display : [ Cable Out ]
g
[ Bluetooth Mode ]
Back Light : 1 sec ickering and OFF
Beep 2
Operation
Mode
PIN PAD ON OFF
Display : [ PIN Mode ]
Back Light : 1 sec ickering and OFF
Nothing
Receiving Data ON ON
Status of Antenna Icon is changed
No displayed
Back Light : OFF
Nothing
On-Line
(Busy)
Printing Data ON OFF
Display : [ Working
...
]
Back Light : ON
Nothing
Stored Terminal Setting
Flickering Flickering No displayed Nothing
Setup Mode ON OFF
[ Setup Mode ]
g
[ Print Status ] <Get out Setup
Mode>
Display : [ Setup Mode ]
Back Light : ON
Nothing
Test Printing ON OFF
Display : [ Print Test ]
g
[ Working
...
]
Back Light : ON
Nothing
Writting Firmware ON OFF
Display : [ Downloading
...
]
Back Light : ON
Nothing
Error
Recoverable
Error
No Paper Error ON Flickering
Display : [ Paper Empty ]
Back Light : ON
1
Happened
g
Beep 3
2
Recovered
g
Beep 1
Cover Open
Error
ON Flickering
Display : [ Cover Open ]
Back Light : ON
1
Happened
g
Beep 3
2
Recovered
g
Beep 1
Auto
Recoverable
Error
Heat Protection
of Thermal Head
ON Flickering
Display : [ Head Hot ]
Back Light : ON
1
Happened
g
Beep 3
2
Recovered
g
Beep 1
n LED & LCD Display / Error