Paper Specifications
Important!
Slip paper must be flat, smooth, and free of curls, bends, wrinkles and folds, all
of which can cause jamming and soiling by ink.
Paper Width
80 to 182mm / 3.15
″
to 7.17
″
Paper Length
80 to 257mm / 3.15
″
to 10.8
″
Paper Thickness
1-ply: 0.09 to 0.2mm / 0.0035
″
to 0.0079
″
Total Thickness: 0.12 to 0.25mm / 0.0047
″
to 0.0010
″
Copies
Original + 2
Copy Offset
1.5mm maximum/15 lines (between top sheet and bottom sheet)
Binding
Top or left
Print Position
Do not use paper with perforations within the shaded area. Perforations may cause the
paper sensor to erroneously report an out of paper condition.
Print Area
Top margin 28.6mm (When top of form sensor is set at a 26.5mm. Top of form detection can be
enabled and disabled using memory switch. When disabled, a command can be used to
reverse feed paper and start printing 20mm from top of paper.)
Bottom margin 38.1mm (13.5mm or 14.0mm when bottom of form sensor is disabled.)
Right margin: 5.1mm
Paper Feed
Drive Stepping motor
Pitch Star Mode: Adjustable in 1/144
″
units
ESC/POS Mode: Adjustable in 1/60
″
units (approximate)
Speed (while printing) 3.5
″
per second
Speed (while ejecting) 4.5
″
per second
Paper feed
direction
No holes in this area
8 mm
To Next Page
Loading...
