Starr Instruments FDG Series - Tolerance, Test Mode, and Peak Time Setup

10
3.2.3 Tolerance
In the Tolerance menu, program upper and lower limit
for GO/NG Measurement.
The upper limit value must be greater than the lower
limit, and both limit value can not be greater than 110%
of the rated capacity. See Fig.3-6.
3.2.4 Test Mode
Test mode can be selected. There are three kinds of
mode: Track, Peak and Auto Peak. (Fig. 3-7) See
2.4.3 Select Test Mode also.
3.2.5 Peak Time
If AutoPeak mode is used, you can set the peak value capturing time interval- Peak Time. Default
setting of Peak Time is 5 sec.
Figure 2-6
Fig. 3-6
Fig. 3-7
Fig. 3-8