2.5 Hand-held or Mounting
The force gauge is a portable Instrument, you can do the testing hand-held, or you also can install the
force gauge on the test stand so as to obtain accurate measurement results. There are 6 M4.0
mounting screw holes on the back，can be fixed on the test stand, show as Fig. 2-2.
NOTE: The depth of the mounting hole is 8.0mm, please choose the
appropriate screws, screw into the depth of the force gauge shall not be
greater than 7mm.
2.6 Storage
Measured results can be stored in the force gauge, so that you can
review or print them later.
Under the measure interface, touch to save value measured, and
the save icon will be displayed.
2.7 Browse and Printing
The values saved in memory can be reviewed in Browse function.
The data in memory can be printed to a report.
To Next Page
Loading...
