2.4.3 Test Mode
This series force gauge has 3 kinds of measurement test mode can choose.
You can select a Measure Mode by touching under the measure interface,
Or can change it in menus (See 3.2.4 Test Mode ).
Track: The real time measuring mode, under this mode, press the zero key the force
gauge will be cleared (remove tare).
Peak: Peak readings will not change until a higher value is measured. Under this mode,
touch the zero key the force gauge will update the display immediately.
Auto-Peak: In this mode, the gauge display a peak value of force in a fixed duration.
The duration time can be set in menus.
2.4.4 Tolerance Limit
The tolerance limits can be set for GO/NG measurement also. See for detail.
If you set the alarm on and a valid limit, The icon will be displayed for within limit, lower
than lower limit or exceed upper limit.
2.4.5 Zeroing
Touch to clear the force gauge in track mode for removing the tare.
To Next Page
Loading...
