Please Carefully Read This First
●Operators should wear protection such as a mask and gloves in case pieces
or components break away from the unit under test.
●Whether the unit is ON or OFF, DO NOT exceed the capacity of the gauge.
NEVER exceed 150% of the rated capacity, or the load cell will be damaged. At
110% of the rated capacity, the display will flash a warning.
●When mounting the Digital Force Gauges, use M6 mounting screws with a
maximum insertion depth of 7 mm into the gauge.
●Hand tightens adapters, DO NOT use tools. Do not use damaged clamp.
●Measure in line tension and compression forces only. DO NOT attempt to
measure forces at an angle to the measuring shaft – damage to load cell and/or
shaft may result.
●Do not attempt to repair or alter this instrument. Warranty will be voided and
damage to the unit may result.
●Use and store within the stated temperature and humidity ranges, or damage
and failure may result.
●If not using for extended periods of time, recharge it for every 2 to 3 months,
or remove the batteries to prevent potential battery leakage from causing
product damage.
To Next Page
Loading...
