4
Installation
Note: Units will be pre-paired with each other out of the box. If they are not paired,
follow the instructions provided in the section for Pairing a Local and Remote Extender.
Network Connect
Installing the USB2G4LEXT2 on a Local Area Network
Requirements
To complete the installation, you will also require the following items that are not
included with the product:
• USB compatible computer (host computer) with a USB compliant operating system
• USB compatible device(s)
• Two Cat 5e (or better) Ethernet cables
• Precongured Local Area Network
USB Cable
Cat 5e Cable
USB cable or device
connectors
Preparing Your Network
Your network must be properly congured to achieve USB 2.0 throughput and
for maximum stability and reliability of your devices. Consult with your network
administrator prior to installation. Using the USB2G4LEXT2 over a network requires:
• Local Extender and Remote Extender to be on the same subnet
• Pre-installed and congured Local Area Network
To Next Page
Loading...
