Steinberg MR816X - Appendix: Technical Specifications; Electrical Characteristics; Input;Output Specifications; General Specifications

Appendix
30 Getting Started
Appendix
Specifications
Electrical Characteristics
Input and Output Specifications
General Specifications
Sample Rate
Internal 44.1kHz, 48kHz, 88.2kHz, 96kHz
External 44.1kHz, 48kHz, 88.2kHz, 96kHz (± 0.1% respectively)
Total Harmonic Distortion GAIN: Minimum 0.004% or less (1 kHz @ +18 dB, into 600 Ω)
Frequency Response
(CH IN to LINE OUT)
fs = 48 kHz 20 Hz–20 kHz, +1, -3 dB @ +4 dB, into 600 Ω
fs = 96 kHz 20 Hz–40 kHz, +1, -3 dB @ +4 dB, into 600 Ω
Dynamic Range
(SN ratio at the maximum level)
104 dB, DA converter (LINE OUT)
97 dB, AD + DA (to LINE OUT)
Hum & Noise
(20 Hz–20 kHz)
Rs = 150 Ω
-118 dB, Equivalent input noise
-86 dB, Residual output noise, Output fader: Minimum
GAIN: Maximum -86 dB (90 dB SN), LINE OUT
PAD: OFF Output channel fader: Nominal, All Input channel faders: Minimum
GAIN: –60 dB -53 dB (57 dB SN), LINE OUT
PAD: OFF Output channel fader: Nominal, Input channel fader (one channel): Nominal
Maximum Voltage Gain 84 dB, CH1 – 8 to LINE OUT
Crosstalk @ 1 kHz
GAIN: Minimum
Adjacent Input
-85 dB, CH1 – 8
Analog Input Type
Input Level
Nominal Level Maximum Level Input Impedance
MIC/LINE/HI-Z jack 1,
MIC/LINE jack 2 and MIC/LINE IN
jacks 3 – 8 (CH1 – 8)
XLR type balanced,
+48 V Phantom powered
–60 dBu to +10 dBu +24 dBu 3.5 kΩ
INSERT I/O jack 1 and 2 (INSERT IN) TRS phone type, unbalanced 0 dBu +14 dBu 10 kΩ
Analog Input Type
Output Level
Nominal Level Maximum Level Input Impedance
OUTPUT jacks 1 – 8 (Line Output) TRS phone type, balanced +4 dBu +18 dBu 600 Ω
INSERT I/O jack 1 and 2
(INSERT OUT)
TRS phone type, unbalanced +4 dBu +18 dBu 10 kΩ
Headphone jacks 1 and 2
(Monitor 1/2)
TRS phone type, unbalanced
4 mW + 4 mW 25 mW + 25 mW 8 Ω
12 mW + 12 mW 75 mW + 75 mW 40 Ω
Power Requirements 40W (PA-30)
Dimensions (H x D x W) 44 x 305 x 480 mm
Net Weight 3.2kg
Operating Free-air Temperature Range +5 – +35
Included Accessories
AC power adaptor (PA-30 or equivalent)
DVD-ROM (Cubase AI 4)
CD-ROM (TOOLS for MR)
Getting Started manual (printed booklet)
IEEE1394 cable
Rubber stoppers x 4