ASSEMBLY INSTRUCTIONS
1.
Remove unit and all parts from crate.
2.
Install the wheels with valve stems facing outward
and tighten wheel nuts to 75
ft
. lbs. Adjust
tire·
pressures. Refer to Service Schedule
in
Section 5.
3. Install the seat (if removed) and connect the
wirring for the seat switch. It is very important to
connect this wiring for safety interlock and
operator presence control.
4. Install the steering wheel (if removed) and torque
the nut to 40
ft.
lbs. Snap the center cover
in
place.
5.
Check all fluid levels. Refer to Service Schedule
in
Section
5.
6.
Visually inspect for loose bolts
or
fittings.
7. Start the unit and test drive to check all functions.
09-380
section 7
7 - 1
2/99
~ - ,,
h
I.,
To Next Page
Loading...