5. faulty components in the system
a. return for repair or have qualified technician
repair as per service manual
C. limited output with no control
1. poor input or output connection to power supply
a. check all input and output connections.
2.Faulty components in torch and wiring assembly
a. Inspect torch assemblies and replace if
necessary.
3.faulty components in power supply
a. return for repair or have qualified technician
repair as per service manual
D. erratic or improper cutting output
1. poor input or output connections to power
supply
a. check all input and output connections
2. current set too low at power supply
a. increase current setting
3.torch is being moved too fast across work piece
a. reduce cutting speed
4.excessive oil or moisture in torch
a. hold 1/8 inch (3.2 mm) from clean surface while
purging and observe oil or moisture
E. No Gas Flow
1. gas not connected or pressure too low
a. check source proper operating gas pressure
2.faulty components in torch and wiring assembly
a. inspect torch assemblies and replace if
necessary
3.faulty components in power supply
a. return for repair or have qualified technician
repair as per service manual
F. torch cuts but not adequately
1.current set too low at power supply
a. increase current setting.
2. torch is being moved too fast across work piece
a. reduce cutting speed
3. excessive oil or moisture in torch
a. hold 1/8 inch (3.2 mm) from clean surface while
purging observe oil or moisture build-up (do note
activate torch)
DISPOSAL OF ELECTRICAL
AND ELECTRONIC
EQUIPMENT
Do not dispose of electrical
equipment together with normal
waste! In observance of European
Directive 2002/96/EC on Waste
Electrical and Electronic Equipment
and its implementation in
accordance with national law,
electrical equipment that has reached the end of its
life must be collected separately and returned to
an environmentally compatible recycling facility. As
the owner of the equipment, you should get
information on approved collection systems from
our local representative. By applying this European
Directive you will improve the environment and
human health!
IN CASE OF MALFUNCTIONS, REQUEST
ASSISTANCE FROM QUALIFIED PERSONNEL.
DUTY CYCLE AND
EXCESSES TEMPERATURE
The duty cycle is the percentage of use of the
welding machine in 10 minutes which the operator
must respect to avoid the power supply output
blocking due to temperature exceed.
If the machine goes into excess temperature:
- The yellow led goes lit.
- It is necessary to wait about 10
minutes before resuming welding.
To Next Page
Loading...
