22
650/800/850 GUEPARD
INJECTION SYSTEM
0122 ...................
Low voltage or break in the TPS circuit
0123 ...................High voltage in the TPS circuit
0131 ...................Low voltage in the oxygen sensor circuit
0132 ...................High voltage in the oxygen sensor circuit
0031
.
..................Low voltage in the oxygen sensor heater circuit
0032 ..................High voltage in the oxygen sensor heater circuit
0201 ..................Fault in the cylinder fuel injector 1 circuit
0202 ..................Fault in the cylinder fuel injector 2 circuit
0230 ..................Low voltage or break in the fuel pump control circuit
0232 ..................High voltage in the fuel pump control circuit
Your snow and swamp-going vehicle is equipped with DelphiMT-05 engine control system
Your vehicle category 3Tb is equipped with the engine self-diagnosis system. Use of the engine control system
self-diagnosis mode:
1. To enter the self-diagnosis mode turn the ignition on, then during 3 seconds turn the ignition on and off 2 more times.
2. When switching the diagnosis mode on, the current engine control errors are displayed on the dash board. The old errors
disappear if their causes are corrected.
3. To switch off the self-diagnosis mode switch off the ignition.
In the self-diagnosis mode the engine control error code is indicated on the dash board with an indicator. The indicator
consecutively flashes every figure of the four-digit error code one by one. In case of several active errors the indicator
flashes them on. The 1222 error indication example.
The list and interpretation of the engine injection system errors:
0107. ..................Low voltage or break in the MAP circuit
0108. ..................High voltage in the MAP circuit
0112....................Low voltage in IAT circuit
0113. ..................High voltage or break in the IAT circuit
0117. ..................Low voltage in the coolant temperature
sensor circuit
0118....................High voltage or break in the coolant temperature
sensor circuit
OFF
ON
sec
1222 code
In case of a failure in the engine ingection control system an indicator flashes jn the dash board « »
0336 ...................Noise in the crankshaft position sensor
0337 ...................No signal in the crankshaft position sensor
0351 ...................Fault in the cylinder ignition coil 1 circuit
0352 ...................Fault in the cylinder ignition coil 2 circuit
0505 ..................Idle speed inspection error
0562 ..................Low voltage in the power supply circuit
0563 ..................High voltage in the power supply circuit
0650 ..................Fault in the control MIL circuit
1693 ..................Low voltage in the tachometer circuit
1694 ..................High voltage in the tachometer circuit
Interpretation of used abbreviations:
MAP - Inlet manifold absolute pressure sensor
IAT - Inlet manifold air-temperature sensor
TPS - Throttle position sensor
MIL - Engine control system error indicator lamp
manufacture website : stelsoffroad.com
To Next Page
Loading...
