TYPICAL
1. Full
2. Add
3. Operating range
3. Remove and check oil level. It
should be near or equal to the
upper mark.
To add oil, remove the dipstick. Place a
funnel into the dipstick tube to avoid
spillage.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until oil
level reaches the dipstick’s upper mark.
Do not overfill.
Properly tighten dipstick. Oil Change
and Oil Filter Replacement
Oil and filter are to be replaced at the
same time. Oil change should be done
with a warm engine.
To Next Page
Loading...
