3
Continued on next page
Always avoid water exposure to all equipment not specifically designed and protected for the purpose.
Moisture causes damage to electronics.
Never maintain and operate this product at poor light settings.
Always ensure all clamping accessories for insertion tool, machine guided tool and workpiece are secure
before usage.
Always store product in a dry, temperate and secure location.
Do not touch the nozzles / hot ends, insertion tools or motors as they can become extremely hot during use.
Do not operate this tool outside.
Always ensure the emergency switch is properly set before operating.
Always ensure you understand the product and how to operate it.
Only use STEPCRAFT-approved replacement parts and accessories for this product.
Never place any portion of the tool or the related accessories in your mouth as it could cause serious injury.
Never operate your desktop 3D system with a computer operated on battery.
Never connect the tool unless using or testing the tool. Do not perform maintenance with the power supply
installed.
Never operate this product if you are tired, ill, taking any kind of medication or are under the influence of
alcohol or drugs.
Never spray ignitable liquids or any other liquid on this product.
Always keep hair and dangling or loose items well away from the insertion tools when the power supply is
connected.
Do not use this product to create any kind of implants, either for humans or animals.
NOTICE: Modification with non-STEPCRAFT-approved components may result in refusal of service by
STEPCRAFT.
This is a desktop 3D system that can hold tools with sharp blades spinning at very high RPM or
tools getting really hot. Always use extreme caution and common sense when maintaining and
operating this product. If you are unsure about ANY function or procedure described in this
manual, DO NOT operate. Contact STEPCRAFT product support for assistance.
To Next Page
Loading...
