STEPCRAFT 210 - Default Chapter; Table of Contents

4
TABLE OF CONTENTS
1 GENERAL NOTES ..........................................................................................................5
2 Work preparation (desktop 3D system) ...........................................................................5
2.1 Installing the software ...............................................................................................5
2.2 Installing the machine parameters ............................................................................5
2.3 Connecting the machine to the computer .................................................................6
2.4 Checking operational readiness ...............................................................................7
2.5 Manual test ..............................................................................................................8
2.6 Verification of the linear axes ...................................................................................9
2.7 Homing.....................................................................................................................9
3 Work preparation ........................................................................................................... 10
3.1 Fixation of the print table ........................................................................................ 10
3.2 Importing the pattern .............................................................................................. 11
3.3 Definition of workpiece zero point (X, Y) ................................................................. 12
3.4 Preparation of the 3D print head ............................................................................ 13
3.5 Definition of workpiece zero point (Z) ..................................................................... 14
4 Starting the first 3D print process .................................................................................. 17