What to do if STEPCRAFT Engine power tool stops and the setting wheel lights up red?
If your STEPCRAFT Engine power tool stops during operation and the setting wheel lights up in red, it indicates that the overload protection has been triggered. To resolve this, switch off the power. Clear the working spindle before starting again. Then, switch the power back on and continue working, but reduce the load or feed rate.
Why STEPCRAFT Engine power tool cannot be switched on and the setting wheel does not light up?
If your STEPCRAFT Engine power tool cannot be switched on and the setting wheel does not light up, it could be due to a couple of reasons. First, check the power supply to ensure there is mains voltage. If the power supply is okay, then the mains fuse may be defective and require replacement.
What to do if STEPCRAFT Engine power tool stops during operation and the setting wheel does not light up?
If the STEPCRAFT Engine power tool stops during operation and the setting wheel does not light up, it might be due to a mains failure. You should check the mains back-up fuses.
Why STEPCRAFT Engine power tool setting wheel lights up blue and it cannot be switched on?
If your STEPCRAFT Engine power tool cannot be switched on and the setting wheel lights up in blue, the carbon brushes are likely worn. Take the power tool to the STEPCRAFT customer service.
General| Positioning Accuracy | ± 0.05 mm |
|---|---|
| Control System Type | CNC |
| Supported Software | UCCNC |
| Connectivity | USB |
| Spindle Speed | up to 24.000 RPM |
| Power Supply | 230V AC, 50/60Hz |
To Next Page
