-7-
Instructions on the use of personal protective equipment:
- Always wear ear protectors during work.
- Always where a dust mark during work.
- Always wear protective goggles during work.
Instructions on operation:
- Do not reach with your hands into the danger zone of the tool.
- Examine the workpiece for foreign objects.
- Monitor the speed. If an uncontrolled speed increase or speed jump occurs, the power supply must be
switched off immediately.
Instructions on service and maintenance:
- Regular cleaning of the power tool is an important safety factor.
- Only original STEPCRAFT spare parts and accessories may be used. Otherwise, the manufacturer will not
accept any warranty claims and cannot be held liable.
4 Setting / Adjustment
4.1 Mains connection
Prior to initial operation, make sure that the mains voltage agrees with the operating voltage stated on the
machine's rating plate.
4.2 Tool change
Pull the power plug during all service work
Wear protective gloves during a tool change. The insertion tool can get very hot during
longer operation and/or the insertion tool’s cutting edges are sharp.
4.2.1 Tool clamping by means of collet
The spindle 1 (Fig. 1) of the milling and grinding motor is equipped with a precision collet 2 (Fig. 1) to hold
the tools. The spindle lock is triggered by the locking button 4 and facilitates tightening and loosening of
the union nut 3 (Fig. 1).
To Next Page
Loading...
