-6-
2.7 Residual risks
Danger
Even if used in accordance with its intended purpose and despite conforming with the
safety instructions, residual risks caused by the intended use will always remain.
- Breakage of the rotating tool.
- Breakage of the tools and risk of the tools or parts of them being hurled away.
- Touching live parts with the housing open and the mains plug not removed.
- Hearing can be impaired when working for long periods without ear protectors.
- Emission of hazardous or potentially explosive dusts (all types) during longer lasting operation without
extraction. Please note the safety data sheet of the material to be machined.
3 Safety instructions
Always observe the following safety instructions and the safety regulations applicable in
the respective country of use!
Allgemeine Hinweise:
- Children and adolescents must not operate this machine. This rule does not apply to young persons
receiving training and being supervised by an expert.
- Never work without the portal system guards into which the power tool is inserted and that are prescribed for
each operation. Do not make any changes to the portal system and the power tool that could compromise
safety.
- Damaged cables or plugs must be immediately replaced. Replacement may only be carried out by
STEPCRAFT in order to avoid safety hazards.
- Avoid sharp bends in the cable. Do not wind the cable around the power tool especially when transporting
and storing the power tool.
- The use of the power tool with water or conductive liquids is prohibited.
- We exclude the use as hand-guided power tool.
- Keep the power tool away from rain or moisture. The penetration of water into a power tool increases the
risk of electric shock.
Do not use:
- Damaged tools or tools that have changed their shape.
- Blunt tools due to the excessive motor load.
- Tools that are not suitable for the power tool speed during idling.
To Next Page
Loading...
