Need help?Do you have a question about the STEPCRAFT D.600 and is the answer not in the manual?
General| Supported Software | UCCNC, WinPC-NC, Mach3 |
|---|---|
| Communication Interface | USB |
| Repeat Accuracy | ± 0.05 mm |
| Repeatability | ± 0.05 mm |
| Power Supply | 230 V AC |
| Number of Axes | 3 |
| Positioning Accuracy | 0.1 mm |
| Maximum Speed | 200 mm/s |
| Spindle Speed | Up to 20, 000 RPM (depending on spindle) |
| Max. Feed Rate | 200 mm/s |
To Next Page
