36
EN
1�4 Required User Skills
The product is only to be operated by technically skilled persons, 14 years or older, who are experienced in dealing with
drilling / milling machines, including CNC machines or 3D-printing machines. The product has to be operated with cau-
tion – basic mechanical skills are required. The improper operation of the product can lead to damage to the product and
property and can cause serious injuries.
Read these operating instructions as well as all accompanying documents in their entirety (including all relevant docu-
ments from your CNC machine, accessories, control software) before using this product in order to become familiar with
the characteristics and the operation of the product. The operator is solely responsible for understanding and reading the
machine user guide and all relevant operating instructions in their entirety as well as for the storage of these documents
in immediate vicinity of the machine. The manufacturers instructions concerning the CNC machine and the tools, such
as the milling motor, are to be adhered to. The CNC gantry milling system as well as associated tools, small parts and
electrical components are to be stored outside the reach of children.
1�5 General Safety Measures
The CNC gantry milling system is only to be used in a technically perfect condition which is to be ensured prior to each
operation. The emergency switch as well as, if applicable, additional safety devices, always need to be easily accessible
and fully functional.
The use of liquids with the machine, such as the application of a coolant pump, is prohibited as it can damage the elec-
tronics. The use of lubrication systems is allowed. Please take into consideration that in this case
a HPL / MDF machine table is not to be used as it could swell and, thus, be destroyed.
Use the supplied safety brush, as it will visually and haptically make you aware of your hand
being in close vicinity of the tool.
1�6 Personal Protective Equipment
When working with the CNC gantry system, the operator has to wear at least the following personal protective equipment
and has to be compliant with the below-mentioned safety aspects:
• Safety goggles for eye protection and additionally gloves (except during operation!) against chips and similar.
• Ear protection against sound and noise.
• No wearing of clothes which can get caught in the machine, such as ties, scarfs, wide sleeves and similar. Addition-
ally, jewelry and especially long necklaces and rings are to be dispensed with.
• Shoulder-length or longer hair is to be secured with a hairnet or a hat to prevent it from getting caught in the
linear guides and / or rotating tools.
To Next Page
Loading...
