43
EN
5 Tools and Accessories
The machine features a 43 mm Euro Neck tool holder (smaller diameters via optional adapters) that can hold a variety
of different tools. System-guided tools can be clamped in the 43 mm euro neck tool holder on the Z-axis. The different
tools can
• feature sharp, rotating insertion tools,
• have sharp, oscillating blades,
• emit class 4 laser beams,
• have sensitive probe tips.
• feature rotating housing parts.
Depending on the respective system-guided tool, you may require (among others) 230 V, 24 V, 30 V, compressed air or
additional signals. You will nd information regarding this in the operating manual of the tool. Please strictly observe and
follow the operating manual of the respective tools! In addition to that, the machine is extendable with supplementary
system accessories.
The following table offers you a selection of available tools and system accessories for your CNC machine. Please see our
website shop.stepcraft-systems.com (for customers from US/ Canada: www.stepcraft.us) for our complete product range.
If you would like to use a system-guided tool like a milling motor of another supplier which is equipped with
a separate ON / OFF switch and is NOT controlled via the PC, you have to make sure that it is professionally
connected to the emergency stop switch. Neglecting this will cause the tool to continue running even if you
actuate the emergency stop switch. There is a considerable risk for personal or material damages!
Product EU Item US Item Image
Milling Motor MM-800 11583 N/A
Milling Motor MM-1000 10022 N/A
Milling Motor MM-1000 DI 11789 11648
To Next Page
Loading...
