17
13406 SE 32nd St, BELLEVUE WA, 98005 WWW.CONSUMER.STEPPIR.COM TEL: (425)-453-1910
The mast plate is connected to the boom using hardware from the high wind kit (PN 09607). If
you haven’t already, make sure to do an inventory of the items shipped to you as part of the kit.
The checklist for the high wind kit can be found on page 11 of this manual.
Install the mast clamps to the back of the mast plate as shown in Figure 2.11. Make sure to ap-
ply anti-seize to the threads of each bolt before tightening to minimize unwanted binding.
Do not tighten the set screws (F) or the
bolts for the saddle clamps until after the
antenna is mounted to the mast.
Qty Part # Description Key
2 10-1021-43 Mast Plate A
4 10-1601-22 Saddle Clamp, 2” B
4 60-0066 Hex Bolt, 5/16” x 4” C
4 60-0046 Nylock Nut, 5/16 D
2 60-0017 Pan Screw, 10-32 x 3/4” E
2 60-0112 Set Screw, 10-32 x 1/4”, Cup Point F
A
B
B
C
B
B
C
C
C
D
D
D
D
E
E
F
F
Section 2.1: Install the Mast Clamps (High Wind Kit)
Older antennas attach the mast plate differently. Skip to page 20 if you do NOT have the
high wind kit.
Use anti-seize on
all stainless
hardware!
Figure 2.11
CONNECTING THE MAST PLATE TO THE BOOM
To Next Page
Loading...
