21
13406 SE 32nd St, BELLEVUE WA, 98005 WWW.CONSUMER.STEPPIR.COM TEL: (425)-453-1910
Section 2.5: Attach Return Tube to the Boom
Skip if you do not have the 40/30 loop
The return tube is installed next to the mast plate, as shown below using the 2E/3E return hard-
ware kit (PN 72-0008-11). Make sure the U-bolts/saddles are positioned over the reinforced
rings on the return tube as shown in Figure 2.51, and be careful not to overtighten the nuts on
the ends of the U-bolts. Align the return tube so that it lines up with the EST on the Driven EHU,
the recommended dimensions are shown in Figure 2.52.
Key Qty Part # Description
A
2 60-0003 U-Bolt & Saddle, 1-3/4"
B
4 60-0046
Nut, 5/16" -18, Nylock,
S/S
A
A
B
Use anti-seize on
all stainless
hardware!
Figure 2.51
Top view
Director Driven
Figure 2.52
INSTALLING THE RETURN TUBE
To Next Page
Loading...
