Steris AMSCO 2532 User Manual

7 — Troubleshooting
105
10041925_M
AMSCO® 2532
Operator Manual
General Troubleshooting
Additional Information
Printer dip switch setting is wrong.
1. Contact STERIS.
Missing or wrong printer driver within
washer/disinfector.
1. Contact STERIS.
7.33 LOAD COMES OUT DIRTY AT CYCLE END
Condition
Load comes out dirty at cycle end.
General Troubleshooting
Additional Information
Wrong type of detergent is used.
1. Refer to washer detergent specifications and follow
detergent manufacturer’s recommendations for
quantity of detergent to be used.
Rotary spray arms clogged.
1. Clean spray arm assemblies (refer to Section 6.11,
Inspecting and Cleaning Rack Spray Arm Assemblies).
Chamber debris screen clogged.
1. Clean debris screen (refer to Section 6.4, Cleaning
Debris Screen).
Sliding water inlet within chamber not operating
properly.
1. Clean sliding water inlet and water outlet
connection (refer to Section 6.5, Cleaning Water
Outlet Connection).
Irrigation ports clogged.
1. Clean irrigation ports (refer to Section 6.12,
Inspecting and Cleaning irrigation Ports on Manifold
Rack).
7.34 LOAD COMES OUT WET AT CYCLE END
Condition
Load comes out wet at cycle end.
General Troubleshooting
Additional Information
Drying phase not programmed in customized cycle.
1. Program in Cycles menu of Supervisor mode.
Drying type not properly selected.
1. Select in Cycles menu of Supervisor mode.
Drying time too short.
1. Set in Cycles menu of Supervisor mode.

Steris AMSCO 2532 Specifications

General

Brand	Steris
Model	AMSCO 2532
Category	Laboratory Equipment
Language	English