3 — Summary of Warnings and Cautions
4
Operator Manual LED202 In-Ceiling Lighting System
11042437_A
Use of accessories, transducers, and cables other than those specified or provided by the manufacturer of
this equipment could result in increased electromagnetic emissions or decreased electromagnetic
immunity of this equipment and result in improper operation.
Use of this equipment adjacent to or stacked with other equipment should be avoided because it could
result in improper operation. If such use is necessary, this equipment and the other equipment should be
observed to verify that they are operating normally.
WARNING
BURN AND/OR ELECTRICAL SHOCK HAZARD
Before beginning maintenance or any cleaning procedures on light assembly, be sure light fixture power
switch (located under access panel on light fixture) is off. Also, be sure light fixture enclosure, front
window and light engine are cool.
WARNING
ELECTRICAL SHOCK HAZARD
Do not remove covers or perform service other than those described in this manual. Refer servicing to
qualified service personnel.
Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed and put
into service according to the EMC information provided in this manual.
To avoid the risk of electric shock, this equipment must only be connected to a supply mains with
protective earth.
WARNING
EXPLOSION HAZARD
Do not use in the presence of flammable anesthetics.
CAUTION
POSSIBLE EQUIPMENT DAMAGE
Always follow manufacturer instructions for concentrations and use of cleaning products.
Do not scratch optical coating on accessible portions of optical core when cleaning; always wear rubber
gloves and use only a clean, white, lint-free cloth when wiping internal surfaces.
To Next Page
Loading...