STIEBEL ELTRON DCE 3-1 Trend - Service Information

OPERATION
Service information
14 | DCE Trend www.stiebeleltronamericas.com
Mounting the water heater
D0000085464-b
21
1 Flat gasket
2 Filter screen with sealed edge
f Mark the 4drill holes, referencing the positioning on the
water heater rear cover.
f Drill the holes and secure the water heater using suitable
fixing materials (screws and wall anchors are not part of the
standard delivery): Countersunk screw, Ø4.5mm, max. di-
ameter of screw-head 9mm.
f Secure the DHW connection pipe with a flat gasket and the
cold water inlet line with the sealed-edge filter screen (from
the accessories) to the twin connectors.
f Seal the openings on the factory-installed water connections
using the plugs from the accessories.
13. Service information
Connection overview/component overview
D0000082950
1
2
3
4
1 Flow meter
2 High limit safety cut-out, automatic reset
3 Pin strips for connected load and temperature setting
4 Diagnostic lights