STIEBEL ELTRON HDB-E 11/13 Trend - 9 Preparation; Installation Site; Minimum Clearances; Water Installation

INSTALLATION
Preparation
9. Preparation
9.1 Installation site
C)
Property damage
Install the appliance in a room that is free from the risk
of frost.
> Always install the appliance vertically and near the draw- off
point. For horizontal installation, see chapter " Installation
alternatives / Horizontal installation of the appliance".
The appliance is suitable for undersink and oversink installation.
Undersink installation
1 Cold water inlet
2 DHW outlet
Oversink installation
1 Cold water inlet
2 DHW outlet
Notice
> Mount the appliance on the wall. The wall must have
sufficient load bearing capacity.
9.2 Minimum clearances
> Maintain the minimum clearances to ensure trouble- free op-
eration of the appliance and facilitate maintenance work.
9.3 Water installation
> Flush the water line thoroughly.
Taps
Use appropriate pressure taps. Open vented taps are not per-
missible.
MEI
Notice
Never use the 3- way ball shut-off valve in the cold water
inlet to reduce the flow rate. The 3- way ball shut-off valve
is intended only to shut off the cold water inlet.
Permissible water line materials
- Cold water supply line:
Pipes made from galvanised steel, stainless steel, copper or
plastic
- DHW outlet line:
Pipes made from stainless steel, copper or plastic
O
Property damage
If plastic pipework systems are used, take into account
the maximum inlet temperature and the maximum per-
missible pressure.
Flow rate
> Ensure that the flow rate for switching on the appliance is
achieved.
> If the required flow rate is not achieved when the draw-
off valve is fully open, increase the water line pressure. If
the flow rate is still not achieved, remove the flow limiter
(see chapter " Installation / Installation / Removing the flow
limiter").
28 I HDB-E Trend www.stiebel-eltron.com